Handlebar OneUp Carbon E-Handlebar 35D, 800L, 35R black

OneUp Carbon E-Handlebar 35D, 800L, 35R

This OneUp Carbon E-Bar is specially designed for use on an e-bike and has integrated ports for e-bike controls. The handlebars are 20% more compliant than other carbon models, thanks to their oval profile tapering to just 20mm instead of the usual 22.2mm. This will give you more comfort and less fatigue on longer rides. Comfortable vertical flexibility is balanced by lateral stiffness to give you perfect response.

The handlebars are adapted for the internal routing of the Shimano STEPS switch units and Bosch LED Remote control centre, and all other units with a connector diameter of less than 6.5 mm and an electrical cable length of at least 650 mm.*

Specifications

• Geometry:
  • Width: 800 mm
  • Diameter: 35 mm
  • Sweep: towards the rider 8°, up 5°
  • Weight: 238 g
  • Rise: 35 mm
• Maximum stem clamp: 65 mm
• Maximum stem clamp torque: 6 Nm
• Max Lever Clamp Torque: 5 Nm
• Minimum trim width: 740 mm
• Grips with a single outer clamp are not compatible with this bar
• Control Bar ends (Bull Horns) are not compatible with this bar
• The E-Bar meets the strict Zedler E-MTB Advanced Plus standard and the international DH standard (ASTM Cat. 5 Downhill).

*Compatibility

• The wire port diameter in the bar is 6.5mm and the minimum switch wire length required to internally route is 650mm
• The OneUp E-Bar features internal routing for Shimano STEPS switch units, Bosch LED Remote and all other switch units with a connector diameter less than 6.5mm
• Specialized, Bosch Purion or Rocky Mountain remote power mode controllers cannot be internally routed through the Carbon E-Bar.
• Switch units with detachable cable:
  • the original wire can be replaced with a cable longer than 650 mm - Shimano EW-SD50 or EW-SD300
• Switch units without cable:
  • using the EW-JC200 jumper and the EW-SD50 power cable