Bike Grips Peaty's Monarch Mushroom Thin mango

Peaty's Monarch Mushroom Thin Handlebar Grips

Peaty's Monarch grips have been designed with such consistency, it's as if your life depended on them - and if you're one of the bravest bikers out there, it might actually be true.

We present to you one of the four variants – Monarch Mushroom Thin. This is a version of the grips with a smaller diameter, a medium-hard compound and a ribbed pattern that allows for greater compression under palm pressure, thus providing better cushioning and providing you with more comfort on every bump, and especially during every landing from a jump.

Years of experience and a focus not only on performance but also on comfort have brought a slightly tapered core shape to the grip design for a better palm position, a larger grip layer from the top for better cushioning with a smaller layer from the bottom for a sure grip, or a zigzag surface that reduces stress on the thumbs. Besides, Peaty's didn't forget to include the sustainability factor, which is why the core is made with a high percentage of recycled material.

So take the Monarch grips into your hands and rule your bike like never before!

Specifications

• Mushroom pattern – ribbing reminiscent of the bottom layer of a mushroom cap. The slats and spaces between them are the same width, allowing compression when the palm is pressed, providing better cushioning and therefore greater comfort when landing from a jump.
• Thin – version of the Monarch grip with a smaller diameter of 30/32 mm (inner/outer)
• Compound hardness 20A – the golden mean; soft enough compound for great grip, hard enough for high durability.
• Conical shape – the diameter of the grip increases slightly from the inside to the outside, resulting in a more natural palm position.
• Offset core – the core is shifted lower relative to the outer grip layer, resulting in a thicker grip layer on the top for more comfort and a thinner layer on the bottom for maximum control.
• Zigzag pattern under the thumb – even better thumb support for reduced blisters and greater comfort.
• High lugs – the lugs under the fingers are more like cutouts in the grip, so they offer you even more grip and contact with the handlebars.
• Half flange and pinky ramp – you will intuitively control the position of your palm on the handlebars thanks to the half flange on the inside of the grip and the raised end of the grip on the pinky side.
• 130 mm for the palm – thanks to the smaller 8mm locking ring, you get a little more space on the grip.
• The core contains 80% recycled material
• Installation – 3 mm Allen key, tightening torque 3 nm