Bike Grips Peaty's Monarch Pro Knurl Thin plum

Peaty's Monarch Pro Knurl Thin Grips

The Monarch Grip is a descendant of decades of hanging onto handlebars like our lives depended on it. Because sometimes they really did.

In Peaty's, they've tested countless different compound and grip pattern combinations, tweaking and testing over and over again in search of a single ultimate grip. So grab a brew and nerd out on the design deep dive below, because Monarch grips are the new Kings of Control.

Specs

• Knurl Texture - "diamond" knurling is a time-tested classic chosen by racers looking for an aggressive and consistent grip for maximum control.
• Thin Version of the Monarch Knurl grip with a smaller diameter
• Inner Diameter: 22.2 mm (compatible with most handlebars)
• Outer Diameter: 30–32 mm
• Grip Length: 130 mm
• High Grip Finger Bars cut invards for maximum grip & feel
• Tapered grip body & offset core for more comfort
• Zigzag thumb pad – even better thumb support for reduced blisters and greater comfort
• Half flange and pinky ramp – you will intuitively control the position of your palm on the handlebars thanks to the half flange on the inside of the grip and the raised end of the grip on the pinky side.
• Material: 20A-hardness rubber compound – soft, grippy, yet durable
• Eco-friendly approach: Grip core made from 80% recycled ocean plastic
• Mounting: 130mm grip area with a slim 8mm locking clamp and 3mm Allen key bolt

Installation Instructions

• Remove old grips and thoroughly clean/degrease bars.
• Slide grips onto bar, ensuring the grips are fitted to the correct side. The ‘L’ and ‘R’ markings on the lockrings indicate left and right oriented grips and should be fitted to the left and right as seen by the rider.
• Orientate correctly so that the crown logo on the end is facing upwards. This will set a good default position for the finger bars and thumb pad. Roll forwards or backwards slightly to suit your riding position and preference.
• Tap the grip fully onto the bar to ensure the bar is driven fully into the tapered core. A firm whack with the palm should be fine—no need for a hammer!
• Tighten the 3mm Allen key on the lockring to 3Nm.
• Ride!