Bike Grips Peaty's Monarch Pro Mushroom Thick brick

Peaty's Monarch Pro Mushroom Thick Grips

The Monarch Pro Grips takes award-winning design of Peaty's to the next level with a dual-compound construction that places the right material exactly where it’s needed. As well as this, the core now features a cut-away channel to dampen hits and reduce small bump chatter.

The result? Enhanced grip, improved comfort, and long-lasting durability. The Monarch Pro's dual compound construction puts the right material properties in the best performing area: Upper half and inner flange: 15a Durometer super soft rubber / Lower half and bar end: 30a Duralite Compound.

The underside, finger bars, and bar ends are moulded from a firmer 30A compound material called Duralite. Duralite foam is a unique blend designed to deliver both exceptional comfort and long-lasting durability. The firmer compound retains its shape and structure which gives a more positive feel when pulling on your grips and is perfect to keep bar ends protected against impacts and scuffs.

Designed with fewer constraints and shaped by more rider feedback, all with the goal of creating something a little more PRO.

Specs

• Dual-compound grips: 15a Durometer Soft rubber upper surface and ZigZag thumb pad
• 30a Duralite compound fingerbars and bar ends
• Impact dampening cut out core
• Zigzag thumb pad – even better thumb support for reduced blisters and greater comfort
• Half flange and pinky ramp – you will intuitively control the position of your palm on the handlebars thanks to the half flange on the inside of the grip and the raised end of the grip on the pinky side.
• Tapered grip core made from 80% recycled ocean plastic
• 130 mm grip area with slim 8mm locking clamp and 3mm Allen bolt
• Two diameters options: 30-32mm Thin option / 32-34mm Thick option

Installation Instructions

• Remove old grips and thoroughly clean/degrease bars.
• Slide grips onto bar, ensuring the grips are fitted to the correct side. The ‘L’ and ‘R’ markings on the lockrings indicate left and right oriented grips and should be fitted to the left and right as seen by the rider.
• Orientate correctly so that the crown logo on the end is facing upwards. This will set a good default position for the finger bars and thumb pad. Roll forwards or backwards slightly to suit your riding position and preference.
• Tap the grip fully onto the bar to ensure the bar is driven fully into the tapered core. A firm whack with the palm should be fine—no need for a hammer!
• Tighten the 3mm Allen key on the lockring to 3Nm.
• Ride!